Jump to content

Talk:Data Link Control

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia
[edit]

The following appears to be a copyvio lifted from CSGNetwork.Com:

Every network interface card (NIC) has a DLC address or DLC identifier (DLCI) that uniquely identifies the node on the network. Some network protocols, such as Ethernet and Token-Ring use the DLC addresses exclusively. Other protocols, such as TCP/IP, use a logical address at the Network Layer to identify nodes. Ultimately, however, all network addresses must be translated to DLC addresses. In TCP/IP networks, this translation is performed with the Address Resolution Protocol (ARP). For networks that conform to the IEEE 802 standards (e.g., Ethernet ), the DLC address is usually called the Media Access Control (MAC) address. -- Stan Shebs

Name for multiple technologies

[edit]

I wikified this article as per the Wikipedia Manual of Style. It was unclear to me whether "Data Link Control" referred to more than one technology. The old version of the article seemed to lean towards two different technologies, so that is what I went with in the new version. I would just like someone to confirm that this is the case and to state in the article what relationship the technologies have to each other, if any. If they are completely unrelated, then there should be separate articles on the topics, unless one of them cannot support its own article. -- Kjkolb (talk) 00:26, 12 March 2011 (UTC)[reply]

Need Netbios reference

[edit]

There is an obscure Microsoft KB article about adding Netbeui protocol to bind DLC to the network card. Similar to DLC, Netbeui is a lookup table of netbios names and MAC addresses. Because they are MAC address oriented these protocols are considered not routable and article should note that. The Token Ring protocol can be routed using extended addresses/forwarding however requires additional equipment. TaylorLeem (talk) 21:30, 8 June 2020 (UTC)[reply]